...the valve cover was removed it was probably damaged by an impatient mechanic. Most covers are sheet metal and the gaskets have an ugly tendency to get sticky over time making removal very difficult. ...
1992 Mitsubishi Pajero factory paint number? (metalic green) Hi, The factory paint code is normally inside the engine bay by the firewall. It would be a sticker type/nameplate for external color and ...
...up two days after it was supposed to have all fluids replaced/filled. If the noise sounds like metal on metal then check your brake linnings...Good
Question about Mitsubishi Passenger
...due head cams before removing the belt you use a lock you can make one even out of bit of wood or a metal plate its just to stop the timing marks from moving. take the belt off and before putting the ...
manifold on the V6 engine. I took off the plenum and the intake manifold and sure enough there is a metal water hose with an O-ring which was leaking. Toyota has a similar setup but uses a rubber hose
iv taken ignition barrel off iv got a bit of metal stuck in key hole how do i take apart the barrel its a mitsubishi pajero 1989 4wd turbo diesel can u not use a stong magnet r twesers to retreve it ?
...the big cog, how do you back it off? Deb half way down the front of the motor you have to take the metal timing chain cover off nasty job if you have air ...
...(worn) clutch there's only a tiny layer left before the clutch plate rivets start eating the metal
Usually answered in minutes!
997 Questions
851 Questions
799 Questions
747 Questions
704 Questions