Questions & Answers for: Janome loops bottom stitch

...loops on it then it is the bobbin tension which is incorrect or the bobbin has been threaded wrongly. A good way to test tension is using contrasting colours top and bottom. Rethread your machine and ...

...lettering when I monogram. When my first stitch is sewn, the bobbin thread makes a loop on top. make sure your bobbin thread is in tension spring on bobbin case, if it is tighten your bottom

...bottom stitches looping. the top stiches look fine, but the underneath stitches have loops. I have tried everything i can think of to stop the problem HELP!!! Raise the presser foot before threading ...

...bottom. If the loops are forming on the bottom it is the TOP thread tension you need to check. Make sure it isn't too loose. Also is the needle the right type and size for the fabric? Check the ...

Janome 6260 not stitching properly. skipping stiches on top and bunching on bottom New needle, clean under bobbin case and look at this.......Looping thread underneath is a top thread tension issue...

...loops on the bottom of the seam? It's important to know... Because loops underneath means the top tension isn't right. Maybe you didn't thread with the presser foot in the UP position... or your ...

bottom side thread occasionally will have a loop about1/16 of an inch in size in the stitch line. I take it back to the dealer and he tests it and returns it to me but when I get home it does the same

bottom gets tangled. It sews fine when I have the walking foot on, but when I put on the different plate for freemotion, everything changes. Is there a different tension setting for the freemotion? Hi

stitch has loops Sounds like a threading issue.
Be sure to install a brand new needle (every 8-16 hours!).
Remove the top thread completely from the machine.
ALWAYS RAISE the presser foot and

...bottom Bobbin tension and the Upper tension to put the loop between the 2 layers of fabric. You set the Bobbin tension first and the the top tension depends on the fabric and the thread used. Your ...