Question about 1991 Integra Hatchback
advise let me know. It would be greatly appreciated. Check any burning points along with the wiring loom in dashboard starting from cig. lighter and if there is a little sign of any melting cable then
...Any help would be much appreciated@@ Seems that u have a bad short I would start looking at the loom running to the dash somewhere wires must be shaved through and touching either against the
...buy a new one ,or solder 2 wires to the bulb and then join this to the two existing wires of the loom,drill a hole in the bottom of the bulb holder so the wires can run through it so you use the ...
...WHERE IT PLUGS TO THE LIGHT MAKE SURE IT IS TIGHT ON ALL THREE PRONGS. AND FOLLOW HEAD LIGHT WIRING LOOM BACK ALITTLE AND CHECK THE ...
...the start/run system and that is a wire connected to the thermostat housing from the transmission loom. This came loose when the thermostat was replaced and would start running when I tugged on the ...
...is using lot of oil there no leaks and all so were imishions plug is to where it conects to wire on loom there a round wire with 3 pin holes in it looks like something missing could that be the ...
...and nav system. The best thing to do in this situation is to try and find a second hand radio loom from a car wreckers/junkyard and fit the radio loom in place or have a autoelectrician wire
...on the opposite side directly across from where the key goes in the ignition,... there is a wire loom screwed to that end with 2 screws, remove this and clean the inside of both sides CAREFULLY, ...
...means that this box does not connect the speedometer sensor, so where can I connect the speed loom to get a reading on my speedo
Question about 1997 TL Series
to the bulbs then the earth/reversing switch is probably faulty or there is a bad connection in the loom
Usually answered in minutes!
415 Questions
424 Questions
419 Questions
283 Questions
325 Questions