Questions & Answers for: how long is 8 mm

...8" W X 19" L X 21"H. IT HAS 4- 5 1/2 bays and 2 - 3 1/2 bays. the holders measure 141 mm long X 22 mm Wide. the plastic on the holder is 111 mm and the medal clip is 30 mm. are these clips available? ...

...8 drive , 13 mm shallow socket and possibly a long one . 14 mm shallow socket and then a 13 mm and 14 mm open end boxed end werench and 10mm werench to get the batterie wire off of alternator and the ...

...mm long (approx. 1 5/8 inches). The undersized stud is 34.5 mm long (approx. 1 3/8 inches). I could not find what I needed so I took a standard 41.5 mm stud and ground off 7 mm which is approx. 1/4 ...

...on a 1999 Pontiac Sunfire! Thanks for your assistance! its a black box 2inches wide by about 4to5 inches long on front of motor probably mounted with 2 8 or 10 mm screw,located top of intake ...

...mm wide - 8 mm long and 1.2 mm fat! The last measurment is important, slimmer staples eject in two or threes in a twist! Can you help me? Peter This is a stapler primarily for upholstering ...

...8 mm). If you cannot get bolts, use threaded rod and cut it to the length you need, using washers and nuts on both ends to create your long bolts. Most better hardware stores will stock the threaded ...

What are the common dimensions of a skateboard? Most boards are about 7 and 1/4 to 8 inches (180 to 200 mm) wide and 30 to 32 inches (760 to 810 mm) long

...8 drive rachet or a special tensioner remover set you can rent from autozone. then you need a rachet set from 10 mm to 15 mm, before to do anything you have to dsiconect the battery, startin with the ...

...8 MM AND DIAMETER APPROX. 3MM SECOND HAND PROTRUSION PUSHES INTO THE HOLLOW MINUTE HAND SHAFT AND OVER A METAL PIN. MINUTE HAND SHAFT IS APPROX. 35 MM LONG FROM CENTER OF MOUNTING RING TO END OF HAND ...

one! Not true. This is a 9mm Hex Head. Went to multiple auto parts stores. They sell 8 and 10 mm..not 9 mm... Ended up buying an Allen wrench set for $10 at Lowe's that had a long 9mm..worked perfect!