Questions & Answers for: Dell LATITUDE what is a jumper plug

...jumper plug on the JPX2 jumper to pins 2 and 3 to erase all settings in System Setup at system start-up. 4. Replace the computer cover. 5. Attach the computer to the electrical outlet and turn it on. ...

...there. pull cmos cell on motherbord for 15 minute then it reset to defaults. Also u can reset with jumper settigns read carefully on mother bord there is 1 jumper near cmos cell u read there " bios ...

...jumper plug from pins 1 and 2. Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds. Replace the jumper plug on pins 1 and 2. If you have tried all the above methods with still no ...

get the account details of the original owner prior to calling Dell. take out the batterie or set a jumper don´t work on newer dell laptops. I use the master password service from http://www.bios

...the date, time and password.If the password is not cleared you will have to short the jumper on the motherboard to clear the password.  Some systems make it easy by just having to ...

...plug and then removing Cmos battery for 30 minutes from the motherboard.  You need to open the PC case, then look for a 20mm (3/4") shiny lithium button cell.some motherboards cmos batteries are ...

jumper plug on jumper A to pins 2 and 3 to disable the password(s).Turn on the computer. Powering up the system with jumper A set to the disabled position erases existing password(s). Before assigning

...jumper plug on the motherboard. The easier way for this model is to remove the coin cell battery for 30 minutes. Here's a link that shows how: ...

...plug connector. Unplug the male connector from the motherboard, remove the RTC Battery. Past this point cannot tell you exact location of those jumper pads. Usually under a piece of Mylar plastic. ...