Questions & Answers for: what is a jumper plug

need to buy the jumper plug where can I buy the jumper plug for my Onkyo TX-DS939 What do you mean by a jumper plug. Are you referring to the preamp jumper plugs?

...jumper plug from pins 1 and 2. Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds. Replace the jumper plug on pins 1 and 2. Else can follow Optiplex User Guides. Hope it helps !! ...

...CMOS jumper (RTCRST) on the system board. Remove the jumper plug from pins 2 and 3. Place the jumper plug on pins 1 and 2 and wait approximately five seconds. Replace the jumper plug on pins 2 and

...jumper Shut down your computer and disconnect the power plug. Identify where the jumpers are located. The location of this jumper varies depending upon the motherboard brand. You should read your ...

...CMOS password reset jumper on the system board.Remove the jumper plug from pins 1 and 2.Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.Replace the jumper plug on pins 1 and

...plug is grounded. attach a jumper wire from the - side of the coil turn key on. touch the jumper to any good ground. then remove the jumper from ground every time you do this the coil should emit a ...

jumper plug on jumper A to pins 2 and 3 to disable the password(s).Turn on the computer. Powering up the system with jumper A set to the disabled position erases existing password(s). Before assigning

...plug into my sata hard drive and do I need a jumper on sata hard drive and what setting would the jumper go on A sata drive doesn't need jumpers. The jumpers were only required when 2 drives used the ...

...jumper plug from the CMOS jumper (CLEAR CMOS) pins 2 and 3. Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1 and 2 and wait approximately five seconds. Remove the jumper plug and replace ...

...jumper plug. Locate the 2-pin CMOS jumper (RTCRST) on the system board. Move the 2-pin jumper plug from the password jumper to pins into the CMOS jumper. Plug in AC power to the system and wait ten ...