2 burners on win2000 I'm running Win2000pro on a 1 gig p111. I had both a cd burner and a dvd burner installed but wanting to back up dvd software I decided to get another dvd burner. I replaced the ...
manual i need a manual for a mx4bs...not sure where the jumpers go for the reset and power for the front panel switches...any help would be greatly appriciated...ty ...
Question about : CDRW 52x32x52 Beige Color Retail (MULAOOD14AS) Burner
plug them in wrong. Set the jumper on the back of the new drive to Master, plug in the IDE ribbon cable, and the 4 pin power supply cable. Mount the drive into the PC in an open slot. Then boot the PC
...plug in the power supply the keyboard lights flush once as if the PC has been turned on) please help Geoff O.K. Try this: Turn the power off at the wall, Pull the GF card and flash the BIOS (refer to ...
Question about AX4PER 845PE P4-533MHz DDR333/5.1/AGP4X/LAN/ATX Motherboard
...plug and play? Hi, Does it POST and can you get into the BIOS? You need to set the FSB to 133MHz and the Ratio to 21x. (I am assuming you did install the CPU correctly and installed the fan.) If you ...
Question about AX4PER 845PE P4-533MHz DDR333/5.1/AGP4X/LAN/ATX Motherboard
...Power Cable back to connector PWR2 Plug in the ATX Power Cable back to the System, That should do it. Here's a really bad picture but it should give you an idea of where the jumper is. Good Luck, ...
Question about S651M (918EM10S50) Motherboard
...plug and Im sure that is here. the min system is easy PSU good, mobo, 1 stick of ram bank0., vga from mobo only to monitor. use the power button correctly and pushed for 10 seconds and released. NO ...
Question about MK77M II (91.88D10.016) Motherboard
...device.Install & power on one at a time.If nothing, then try clearing CMOS with onboard jumper to set back to factory defaults. ---------------------------------- I wasn't sure you had
Question about AX45-V (91.88I10.004) Motherboard
hard drive doesnot spinup when ide cable plugged but spins up without it plugged in. Are there any jumpers that need to be set? make sure you ide cable is plugged in correctly and set jumpers to ...
Usually answered in minutes!
45 Questions
29 Questions
20 Questions
18 Questions
20 Questions