...jack stands. Loosen the two bolts holding it up. It is located at the rear of the engine close to the transmission on the drivers side. disconnect the wires and mark so when you put it back in you ...
LOCATED THE TIRE JACK AND LUG WRENCH FOR MY 2001 MERCURE VILLAGER. CAN SOMEONE HELP ME? Have you loked in the rear qtr panel they have little door 12x12/ Please rate my response thank you very much On
...jack up the engine only about an inch after loosening mount bolts or enough to attain enough clearance to remove old mount, but not too high, you may want o remove the other mounts located (if any on ...
...following locations: Item Location Spare tire Under the vehicle, just forward of the rear bumper Jack assembly Under the third row bench seat in the tool bag Removing the jack and tools 1. Lift
...jack located on 97 Mercury sable The car jack providing that some one has put it back in the right spot is located in the trunck over the top of the spare tire. You will have to lift up the floor mat ...
...jack lifts). 4. using the 22 mm socket wrench take the bottom nut off the mount which is located under the right side of the crossbar. 5. using the 5/8 socket remove the top bolt that attaches the ...
...LOCATED A THE REAR BOTTOM OF THE ENGINE, U WILL NEED SAFETY JACK STANDS AND A HYDRAULIC FLOOR JACK TO GET THE CAR AS HIGH AS POSSIBLE, DONOT USE A BUMPER JACK! ALWAYS USE SAFETY STANDS, OK THAT SAID ...
replacing a tire...where is the location for setting the jack? I cannot lift the car high enough off the ground just behind the front wheel under the body there is what is called the (pinch weld), it ...
jack up points need to lift cougar for wheel inspection. want proper jack spots here are some good locations :
...V6. Where are motor mounts located? Under the engine. You must have the car off the ground and high as possible to get access to them, you will need jack stands and a good hydraulic jack. BE
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions