Questions & Answers for: husqvarna chain slipping

problems when trying to refuel husqvarna 316. What should be in the hole at the top left hand side of fuel tank, just in front of plastic tank to carb fuel pipe, as when I try to refuel the petrol ...

should kick back bar stop chain when forward or back? I think stop is forward, being designed to stop the chain if your hand slips off the handle. --W/D--

Chain slips Hello I have a Husqy 350 18" chain. It is about 6 years old. I just replaced the chain. Basically, problem is when I go to cut and put pressure on the chain against the tree the chain ...

CHAIN SLIPPED OFF HOW DO YOU GET IT BACK ON 14 IN HUSQVARNA There's two 1/2 inch nuts on the side of the cover from which the bar protrudes. Remove these nuts and the cover -- leave the bar loosely in

...chain is probably slipping off of the drive gear causing the chain to "lockdown",if this is your problem,that gear will have to be replaced.Any small engine repair shop in your neighborhood can ...

cannot see how to remove the chain bar remove the two nuts on the cover and loosen the screw at the base of the bar on the engine. This tightens and loosens the bar. But makes it easier to remove the ...

husqvarna 435 when not in use all the bar oil leaks out threw the oiler Have you cleaned it thoroughly? the gear that is on the crank shaft,if i remember is a nylon gear.some times they look prefectly

transmission is slipping are you sure this is not chain driven? maybe the chain is slipping. there is no transmission in this model.

chain from a husqvarna 235e chainsaw? Like this or pretty close. **** brake while expanding chain brake binder by pulling brake handle towards left-hand (wrap-around) handle grip, hard, until it locks

chain slipping at high rpms on Husqvarna 55 can the clutch be adjusted to keep the chain from slipping? sounds like you need to replace your clutch springs. also check your sprocket for wear