Questions & Answers for: Chevrolet 2500 how to reset limp mode

air conditioner in 1998 chevy 1 ton blowing air through the defoster. Manual or electronic A/C control head? If electronic either the A/C control head is not putting out a signal to open or close the ...

Ad

...can I do to get it to go off? nex time take it to one of those oill change places and have them reset it they have the code box to reset all those code lights on most cars and trucks no all you

Ad

I HAVE TO PUT THE SYSTEM IN BYPASS MODE TO TIME IT BECAUSE I INSTALLED A MSD DISTRIBUTOR AND COIL need to unplug a single wire it is behind glove box set timing then plug it back together

Question about 1997 C/K 2500

1 Answer

truck wont go in gear I got a chevy 2500 with a 6.5 diesel i was driven down the road with the cruise set on 60 and the rpm went up real fast so i took the cruise off and hit the gas and the truck ...

Question about 1997 C/K 2500

2 Answers

where is the ecm location on a 1993 suburban? I am assuming this is my problem with the truck. I have replaced distributor,coil, fuel pump and filter with no change. Truck runs great till normal ...

Question about 1997 C/K 2500

1 Answer

tow mode is not working on my 2005 chev 2500hd Ok i would start by checking your fuse which is located in the fuse block under the hood, if that is ok i woulf check that switch on the shifter or make ...

Question about 1997 C/K 2500

1 Answer

when in fwd I have no rear wheels engaged,only front wheels engaged.I have the transfer case apart and the range and mode shifting forks look like new sincros look good as well.what am I over looking?

Question about 1999 C/K 2500

1 Answer

...mode. The car misinterperates this and thinks its being stolen or hotwired because it is NOT getting that signal from YOUR specific key. There is where the security light turns on and shuts down your ...

Windshield wipes want turn off on my 1991 Chevy 2500 it could be the wiper switch having a short while off, (or might be stuck in intermittent mode) or the wiper electronics not having "park" ...

...limp mode at startup can reset and drive after disconnecting battery. Transmission never goes into limp mode driving or when truck is running only at startup. Throws shift codes for 1-2 2-3 3-4 and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...