Questions & Answers for: Jeep Cherokee horns buttons steering wheel working

...steering wheel. PLEASE do not try to replace it yourself. If not done by a qualified mechanic, the airbag can go off. my horn quit working and i have already replaced fuses and it still won't work i ...

...connection could be bad, Like if ththeres rust try to scrape it away & Try that. The fuses are located under the steering wheel or the drivers side. I had the same problem..ended up being a

...horn does not even work if you try to honk replace the horn contacts under the steering wheel. You need to check the wiring in the steering column. You have a short and/or broken wire in the

steering wheel comes loose and pops out. To repair this remove the steering wheel with a puller kit. Then remove the locking plate with a special puller for this also.Now you can see the pigtail wire,

...steering wheel having a broken filament, the part is known as a clock spring contact, u will need to properly disarm the airbag and remove the steering wheel to access the part. WARNING: Failure to ...

Horn not working on a 99 cherokee. Checked fuses and horn. No power getting to the horn. Sounds like horn contacts in steering wheel are bad

...- Horn contact in steering wheel could be bad or disconnected, the obvious fuse, or horns themselves are bad. To test horns(behind grill) run a hot lead from + side battery to horn ...

...the horn wont sound consistantly? You would have to remove the horn button or insert on the steering wheel to either fix the contact or spring which causes the horn to function when the 2 make ...

STEERING WITH HORN CONTROL BUTTONS.YOU NEED TO DISABLE AIRBAG IN STEERING WHEEL WHEN REPLACING AIRBAG AND HORN CONTROL BUTTON PAD.JUST TURN OFF RADIO FIRST, THEN DISCONNECT REMOVE THE NEGATIVE BATTERY

...steering wheel down the shaft with the nut. Connect the wire feed to the horn buttons. Connect the feed wires and tighten the air bag retaining nuts to 90 inch lbs. (10 Nm). Ensure the air bag is ...