...hold bobbin case in left hand bobbin and in right hand with the thread going away from you across the top of the bobbin hold the bobbin, the top of the **** the thread goes in to should be up put the ...
...it to the hand knob, unscrew the end to loosen the mechanism, then place thread onto the bobbin, holding one end. With the lock loosened, depress the pedal, and holding the thread, it should spool ...
...the thread using scissors. Slide the bobbin winder to the left and remove the bobbin. Hold the hand wheel in your left hand and tighten the hand wheel knob with your right hand by turning it ...
...drive motor stretched and I need to replace it. I removed the top plate and removed the 2 screws holding the right side plate. However, I can't remove the right side plate because the hand ...
...doesn't move at all sounds as though the hand wheel at the right end of the machine needs tightening by hand to engage inner workings. Hold the larger wheel with one hand tighten the smaller
...Hand wheel Knob A will not move. There is a screw on Knob A that I loosened but the wheel still will not move. If you have an instruction booklet, directions on are page 20. The small box you will ...
Question about Memory Craft 3000
...hand to hold the case while bringing the bobbin to the case. Some machines have you put the bobbin in the case with the tread facing towards your left hand and others facing the right hand. While ...
...Hold the hand wheel with one hand and keep it from moving. With the other hand, loosen the knob in the center of the hand wheel by turning the knob towards you. If the thread is not already on the ...
Question about Memory Craft 3000
...Hold the hand wheel steady so that it will not move with one hand. Use your other hand to rotate the knob in the center of the hand wheel towards you. When the unit is properly disengaged, the motor ...
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions