Questions & Answers for: Andis hold my hand

...the trimmer pull hair to.there might be a little plate on the inside of the trimmer and its not holding the blades tight.adjust that not to tight though then the trimmer wont cut hair between ...

clipper turns on but blad isnt moving! clippers turn on but cutting blade doesnt move. unlock with hand, lubricate

...Hold the blade compartment in your hand upward with smaller blade on top of the larger blade. On the clipper in between the two hole where screws go there is a small arm with a round shaped tip. Put ...

How do i remove the detachable blade on the Andis bgrc On some of these Andis BGRC clipper they have a lock hinge just pull the blade off with your hand some times they are hard to pull off.you may ...

MY ANDIS T OUTLINER BLADES ARE CLOSER TO THE LEFT THAN RIGHT AND ARENT CUTTING RIGHTHOW CAN I ADJUST THEM e-mail me and I will have photo's on hold to adjust them. [email protected]

how to replace cam drive on andis super 2 speed Please let me know how to replace the cam drive on andis super 2 speed ok you need to take the upper cassing off, remove the hinge assembly and the ...

...hold the blade with one hand and with your Philips screw driver tap the cutter blade back lightly until the cutter teeth are 2/32 back from the comb blade. the cutter blade which is the smaller blade ...

Where can I get a replacement screw for the T outliner clipper body? What size is it? One of the 2 screws that holds the clipper together is missing Where r u based

what if you remove the screw that hold the blade in Then you have just ruined your blade. Those screws hold the cutting edge level below the edge of the blade. Without those screws aligned and ...

...Adjust your blade. Remove it from the clipper, and then loosen (don't remove) the two screws that hold the blade and cutting edge together. Use a FLAT surface, like a ceramic sink top or flat piece ...