Questions & Answers for: Oldsmobile heater cable

Question about 1994 Achieva Special Edition

1 Answer

...heater core in a 1994 olds. achieva. Disconnect the negative battery cable. Drain and recycle the engine coolant. Raise and safely support the front of the vehicle. If necessary, remove the rear ...

Ad

Question about 1995 Cutlass Ciera

1 Answer

...cable could be in the way, but an expert opinion would be much appreciated. the next time it does this, locate heater blower motor and either give it a tap or grab a hold of it and see if it changes ...

Ad

Question about 1994 Cutlass Supreme

2 Answers

...cable to the heater control valve moves. The rest depends on how handy you are. Should be an easy repair for your local shop. why is my car blowing out cold air in the bottom vent n the top its ...

Question about 1998 Cutlass

1 Answer

...the heater core are hot sounds like thelink on the motor is not moved round to hot,get under the dash and move all cables by hand until you get heat.you can then cable tie the cable where you need

Question about 1998 Cutlass

1 Answer

...the retaining screws...Reconnect the heater hoses, electrical connectors and negative battery cable; Refill the engine with coolant, start the vehicle and check for leaks... ...

...heater core Disconnect the negative cable from the Oldsmobile Alero's battery. While the car is securely raised on jack stands, drain the engine coolant into a clean container. Most models don't have ...

...cable and drain the cooling system. Disconnect the heater hoses from the heater core inlet and outlet connections in the engine compartment. Allowing residual coolant from the heater core to drain. ...

...the heater element. To install: Coat the new heater with sealant, then install the reverse order of removal. Fill the engine with coolant, connect the battery cable. Start engine and check for ...

...cable. Disconnect the heater hoses from the heater core. If equipped with electronic climate control, perform the following procedures: Disconnect the wires and the hose from the programmer. Remove ...

...heater core at all times, but is controlled by a cable-operated, or vacuum operated "blend door" located inside the heater box. If you are not getting heat to the vehicle, there are a few possible ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...