...Goodman GMP075-3 heater has no igniter voltage. The blower runs, thered light lites then goes out, then blinks 3 times. I've changed theboard, but still the same problem. The igniter ohms out ok. ...
Question about GDS80904BNA Open Flame Heater
goodman gas heater 075-3 will not start,the unit comes on but there is no voltage to the igniter,the OBD shows one blink once the draft motor starts the proof switch will make (a small rubber tube ...
Question about GDS80904BNA Open Flame Heater
...goodman heater will not provide heat,the fan runs,and the vacuum switch seems ok but the igniter shows no voltage,I can hear the gas valve clicking as well,the unit cycles a few times and then shuts ...
goodman gmt or gmth not igniting burner. We have goodman gmt or gmth not igniting burner. We have been under high winds for days. Have shut off power and gas control switch multiple times to try to ...
...Goodman heater has a problem igniting at times My Goodman heater has a problem igniting the burner at times. It will start the purge then you will hear the gas coming for a few seconds then nothing. ...
...goodman heater 97 efficent .turn thermotsate on draft inducer motor start for 30 sec igniter turns on . no gas If the gas valve is getting 24 volts and still not responding then replace it. If it is ...
How do I access pilot to turn on heater? A GMS Goodman furnace does not have a pilot light. It is electronic ignition.
Goodman GMP100-3 igniter will not ignite I have a Gmp100-3 the igniter will not glow. the system wil try to start the fan starts there is a noise (that used to be when the ignitor woud start) i smell ...
Question about GMS90703BXA Heater
Goodman GMP100-3 home furnace status lite is constant red Goodman GMP100-3 main burner will not ignite dont see any glowing or a spark hear a click but no flame and status lite is red check continuity
Question about GMS90703BXA Heater
goodman gmt070 inductor fan clicks on, pilot glows, nothing Inductor fan clicks on, pilot glows, nothing happens. Then it repeats the above cycle & ignites. Possible bad igniter...igniter should read ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions