Questions & Answers for: furnace shuts few minutes restarts

...furnace shuts down. furnace is less than 15years old.Its electric pilot with gas heating.The pilot lights alright just cant get the burners to ignite at all times.Sounds like the heater is on all the ...

...furnace again a few minutes later if there is still a call for heat from the thermostat. After enough unsuccessful tries at getting the system up an running, it will go into a hard lock-out and won't ...

...furnace and air conditioner. When the air conditioner is running, it runs for about 10-15 minutes, then shuts off for about 5 seconds, then restarts. Could you tell me what would be wrong? I think ...

furnace model GKS91155DXAD. The blower stays on. After turning power off for a few minutes then back on, the draft blower comes on for a few seconds then goes out but the blower comes on and stays on.

Furnace GMS9/GCS9 Cycles twice and then fires up most of the time and then it won't fire and shuts down. To restart it We have to shut the 110/115 power off for a few seconds and turn it back on and ...

furnace goes through what appears to be a reset where the flame drops out, the air circulates for a few minutes then the flame tries to come back on. The gas valve cycles open/closed several times but

...furnace burners will go out, shortly after activating. The thermostat works fine, changed out with new one. The system, activates, the fan comes on, the igniter lights, the burners come on, They blow ...

...furnace false starts even when off or temperature set lower than current. When i turn My 10 year old Carrier 58STA/STX off, after a few hours it attempts to come back on (I hear a startup sound) and ...

...shuts the door, and the fire depletes the available oxygen and the fire will start producing copious amounts of CO which is a hazard. Most fireplaces have a fresh air supply available to provide ...

...furnace lights, but then goes off after a few minutes of operation, it sounds like your spill (rollout) switch, sail(air flow) switch, or high limit switch may be bad. These are thermal bimetal snap ...