...front of your machine. The presser foot must be in the up position for that guide to open and allow the thread to correctly "seat" in that guide. Try this...Before you thread the needle, pull on the ...
...foot. Right in front of the screw that holds the foot on, there is a hook that opens on the left side. Slide the thread behind this hook, and then thread the needle from front to back. 7. Hold onto ...
foot will fit this machine. Does your machine info plate say "made in Japan" or "made for Elna" anywhere? Is it about 30 years old? I'm pretty sure this was a "made under licence
...front of the foot; buy any new feet with same code format.As to where to buy, I always start with the manufacturer/distributor in my country first. So start with www.bernina.com, go to your ...
...front panel, below the hand-wheel and has the serial connector to the PC, the multi-way connector to the embroidery unit and the foot controller socket. It would be unusual to have to replace this ...
...foot features an accurate 1/4" and 1/8" on both sides of the needle. It also has a 1/4" guide in front and behind the needle to allow accurate 1/4" stops and starts from the end of the pieces being ...
Question about Virtuosa 160
...front near the needle where you can run the machine with foot pedal ...just what I would experience when my Bernina was running, or not, ... Sewing Machine Repair ' ThriftyFun ...
Question about Virtuosa 160
...front of the foot. It could also be that the fabric you are sewing is slightly sticky, so it is sticking to the presser foot. You can try laying a piece of tissue paper over the top of the fabric as ...
Question about Virtuosa 160
...foot on my Bernina 1630 Go to straight stitch in menu then there are small buttons beside the stitch width dial that when depressed will move the needle left or right. It's been a while since I have ...
Question about Virtuosa 160
...front of your Bernina 1130 sewing machine are turning on but it is not working, it may indicate an issue with the machine's electronics or motor. Here are a few troubleshooting steps you can try: ...
Usually answered in minutes!
64 Questions
435 Questions
168 Questions
165 Questions