Questions & Answers for: Harley Davidson FLHRS - FLHRSI Road King Custom exhaust valve

...exhaust valve has sucked up some cold air. The engine idles fast, because more air is being introduced, and not metered by the injection system. (The exhaust valve thing. Exhaust valves are supposed ...

...side of the bike, on the end of the transmission is the clutch release mechanism. It's behind the exhaust system and the clutch cable runs into it at the bottom. In this cover is a plug that takes

What's the remedy on backfiring on the back cylinder only? I have solved the exhaust leak already, but there's still popping but only the left exhaust only. are they stock pipes?...is it injected or ...

...and on idling. Hi Vecayap, you could be sucking air at the rear cylinder intake seal or exhaust gasket. Good ...

...of HD aluminium foil, unfold it and fold it into 4, and then place it between reservoir and the exhaust and wire it in place. The reason you do this is to create air spaces that will dissipate ...

on a 2005 road king custom...exhaust flange nuts to head new gasket installation torque? 60-80 INCH POUNDS.

Fast idle Engine won't decelerate when stopping Hi Anonymous, either you have an intake leak or your IAC valve is gummed up. Good Luck

Where is the fuel reserve switch in a Harley road king Hi Anonymous, if you are carburated there is a fuel valve on the bottom left side of fuel tank, if you are injected there is no valve or switch ...

bad gas bike wont run? left bike in garage while on extended vacation.when I came bike would not start.Motor turned over. Hi Anonymous, and the usual suspects are: 1. Fuel tank empty 2. Fuel supply ...

...$150. But if your willing to give it a try here is the short version: remove necessary parts of the exhaust system to gain acess to the transmission side cover, next back off jam nut and turn in ...