Questions & Answers for: Mazda 626 drive belt

Question about 2001 626

1 Answer

timing belt the manual says to have this replaced...do i have to You should replace your timing belt as regular maintenance. I usually will let the belt go to 80k for the 1st one. The rest of the time

Ad

Question about 1995 626

1 Answer

Drive Belt I am trying to replace my alternator and can't seem to locate the nut to loosen the drive belt. I am not too familiar with your vehicle, but if it has a serpentine belt there is a tensioner

Ad

drive belt squealing I have a 1996 1.8 mazda capella auto. I have just replaced the alternator drive belt because the old one was worn & squealed when I first turned it on for about 30 seconds.But

...timing My car squeals when I start it. Is it the timing belt. Not the timing belt....more like the sepentine or accessory drive belt (your fan belt), or bad bearings in the alternator or idler

...drive belt so easy to change after removal of under wing cover to access /see pump b4 you remove drive belt would advise you to slacken off the water pump pully 1st while it is held by drive belt to ...

put a new timing belt on, car still wont start. Timing belt and alternator belt broke while i was driving. put new belts on, car still wont start. any suggestions? hi put the #1 piston up with the ...

drive belt is this common When your drive belt becomes old and stretches so it is no longer tight enough the belt will make a loud squealing noise and will need to be replaced. While the drive belt is

Question about 2001 626

1 Answer

...drive belt the same belt as a serpentine belt on a Mazda 626 year 2001? Yes if you only have one belt and that is a serpentine belt then that is your drive belt. Normally a drive belt does not refer ...

Question about 1993 626

1 Answer

...belt, drive belt, serpentine belt, accessory belt, fan belt, engine belt routing diagrams for all types of car models? Click the link below: ---- ...

Question about 2000 626

1 Answer

to release tention to change belts in engine The tension is spring loaded and you use a wrench  or 1/2" drive ratchet end and move away from the direction of the belt tensioner tensions the belt.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1999 Mazda 626
1999 Mazda 626

544 Questions

2000 Mazda 626
2000 Mazda 626

410 Questions

1998 Mazda 626
1998 Mazda 626

356 Questions

1995 Mazda 626
1995 Mazda 626

269 Questions

1997 Mazda 626
1997 Mazda 626

277 Questions

Manuals & User Guides

Loading...