oil leak on breather have a oil leak and think it is crankshaft breather but do not know where this is located. No oil breather on any vehicle shipped to the USA after 1974
...check for timing belt failure by removing black plastic engine cover on side. if ok and tight check crankshaft sensor these are a common failure.. hope this ...
Font Harmonic balance pulley setting for discovery 3 2005 V6 4.0 l petrol It should be keyed on the crankshaft as well as inside the balancer, no adjustments or settings necessary.
...drive, pump coupler or pickup have failed, or you have a major bearing failure somewhere along the
crankshaft sensor replacing crankshaft sensor freelander http://www.landroversonly.com/forums/f40/location-crankshaft-sensor-39633/
Question about 2004 FreeLander
...04 does not start... but will crank.... pressure is at 53 ... i changes the camshaft sensor and crankshaft sens truck does not want to start.... but, will crank... I check the pressure and it is ...
Question about 2002 Freelander
I have overhualed my 1.8K series engine taken the crankshaft from std to .10000 now i need to buy cons and big end bearings. Can anyone help with part numbers for the same? Jun 06, 2014 Con rod and ...
Question about 2002 Freelander
My engine is a v6 03 land rover freelander timing mark is like showed in diagram on crankshaft but piston is not tdc On the freelander it's done that way so none of the pistons strike the valves like ...
how do you remove the crankshaft dumper pully? Published: 11-May-2011 Engine - V8 4.4L Petrol - Crankshaft Pulley In-vehicle Repair Special Tool(s) Holding Tool Crankshaft Pulley 303-893(LRT-12-080) ...
Question about 2006 Range Rover Sport
2004 land rover freelander crankshaft sensor position location please I am working double shift trying to locate a crankshaft sensor position in my 2004 land rover freelander, Please where is it ...
Usually answered in minutes!
931 Questions
392 Questions
318 Questions
325 Questions
340 Questions