Questions & Answers for: Mercury connecting hot water radiator

water pump and slide hard tubing in hose all the way up to where the bypass connection is feeling the obstruction...rotating the hard tubing as you gently shove it thru heater core hose. Slide it back

...hot water valve vacuum line reconnected ? was all air purged from entire cooling system after engine repplaced ? were heater hoses connected properly to get correct direction of flow ? are hoses to ...

hot coolant. Also, when draining engine coolant, keep in mind that cats and dogs are attracted to ethylene glycol antifreeze and could drink any that is left in an uncovered container or in puddles on

hot it will burp out some air and replace it with water from the reservoir. But some cars trap too much air, so also have a valve on the engine that can be opened up. Cars with the engine far from the

water pump and serpentine belt. Check the coolant level in the recovery bottle or surge tank, usually mounted on the inner fender. With the engine cold, the coolant level should be at the FULL COLD or

...hot. anyway after parking and turning the car off the radiator reservoir would be nearly full all the way up to the top and then water/coolant would spray out of the little overflow hose (little tiny ...

water pump and slide hard tubing in hose all the way up to where the bypass connection is feeling the obstruction...rotating the hard tubing as you gently shove it thru heater core hose. Slide it back

...connecting them together should cause the fans to operate. If the cooling fan thermal switch has three, four or more wires it would be prudent to study a wiring diagram before bridging any pair of ...