...preasure comes on the chain it slips and stops turning. How can I fix this? Try washing out the clutch interior with carburetor cleaner from an auto parts supplier and blow out with compressed
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...revs up.the centrfical force tries to throw these shoes outwards,that in turn brings them in contact with the drum and makes it revolve.The drum having the cog onthe back starts to revolve with the ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...idle and adjust L CW until the engine runs fairly well, yet will allow it to 'follow the throttle'. Set the idle speed screw til the chain stops moving, but keeps the engine running. Hope this
Question about 16 Inch Gas Chain Saw MCC1635AK
...chainsaw tick over, it revs up but not tick over. also, cannot start it after 2-3 mins of usage, why? Check the air cleaner and muffler for plugging. Try turning the idle speed screw (not the L jet ...
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
stops (lightly) then back out CCW 1-1/2 turns each. This is a basic setting which should allow the engine to start and warm up. After warm, pull the throttle full on and turn the H jet needle CW until
...revs clean, now adjust the idle screw so the engine idles without the cutting chain rotating around the bar, the H screw should be about right however if it sounds too rich at full throttle srew the ...
...chainsaw model 358-351910-18. Saw runs great at idle or while not cutting wood, when starting to cut wood just after the entire bar gets into the wood engine bogs down and chain comes to a complete ...
Question about Pro Chain Saw 46cc 20"
Chainsaw is running,but doesn't cut.what is possible causes of this? Depends on what you mean when you say 'it doesn't cut'. If you pull the trigger and the chain goes around, but it won't cut ...
Question about 14 Woodshark Chainsaw
...cutting a limb and suddenly the chain stopped moving with the engine still running. Sounds silly but have to activated the chainbrake by accident.? The black handguard by the top handle is the ...
chainsaw it will start up and run as long as i keep my finger on the gas trigger but when i take my finger of the trigger the engine die cut off what could be the cause how can i fix it. Try adjusting
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions