Questions & Answers for: Poulan carborator

I can't figure out what tool to use to adjust the carborator on my Poulan Preditor P3516PR chain saw. I thought it required a 1/4' hex tool, but that does not seem to be turning the adjustment screws.

Where do I find the carborator and how do I clean it? The carburator should be located under the air filter. When you remove the air filter, get some carburator cleaner and spray carb and linkage. ...

carborator overfilling the bowl gas bubbling Your float is stuck open and needs to be set, a piece of dirt gets in there and holds the float open, sometimes it is just too high. You can take the top ...

i have a weed eater trimmer that i replaced the gas lines but now when i pump the top of the carborator no gas gets to the carborator and the trimmer will not start. REVERSE THE TWO FUEL LINES .. ...

CARBORATOR SCHEMATIC FOR POULAN WILD THING 18 go to eReplacementParts.com : Power Tool Parts and Tool Repair

the carborator iss not adjusted how do you set the carborator on this The idle screw is in the hole right above the primer bulb. Turn clockwise to increase idle. Adjust in small increments.

I need to know how to set hight and low on the carborator Make sure choke is fully open, then run engine at full speed adjust high jet with a screwdriver - what you do is turn jet one way until revs ...

how do you repair a Bolens push mower that's leaking gas out of the carborator? You will need to rebuild the carb sounds like the float is sticking and allowing the gas to keep flowing. The needle ...

do not know witch fuel line is the feed on my woodshark model 1950 carborator? i do not know witch fuel line feeds the carberator and witch one feeds from the bulb Depending on which carb you have, it

a diagram so i put the lines on correctly, i think i put the lines on backwards after i cleaned the carborator. Poulan might be able to supply the diagram