Questions & Answers for: canon control center

...Canon Customer Support Center for further assistance at 1-800-828-4040. Support hours are Monday thru Friday - 8:00 AM to 12:00 midnight; and Saturday 10:00 AM to 8:00 PM (all times EST). ...

...canon service center in the philippines. pictures have lines!!! Sounds like you might have a defective CCD imager. If so, Canon should fix this for you for free, including free shipping both ways. ...

...center. Item: Canon eos 30D digital Camera. I need to update firmware version 1.0.6 I FOUND A COUPLE OF SITES TO TRY FOR THE SOFTWARE. I DO NOT ENDORSE EITHER SITE, JUST REFER FOR YOUR USE. HOPE THIS ...

support center at http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=257&modelid=14723# they will provide you assistance for cannon printer problems.

...canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=257&modelid=14723 In the search window in the center of the screen, type "bluetooth settings", then ...

get a new door. Hi, Contact Canon themselves for a service center near to you. http://www.usa.canon.com/consumer/controller?act=SupportIndexAct Regards. Is there any way to replace the battery's door

control is shut off. When I try a known good main controller, I get an E354 Code. Still have black copies. Need Help. Hi, As I see that you have done near about all troubleshooting steps possible with

Canon Customer Support Center for further assistance . Contact Information for Inquiries Canon U.S.A., Inc. Customer Support Center Phone: 1-800-OK-CANON (toll free) 1-800-652-2666 TTD: 1-866-251-3752

...Canon service center to have it replaced and have the counters cleared. When you clean your print heads, the ink is stored in this absorber and it gets full over the lifetime of your printer. Go to ...

canon mx308, but the lcd of this printer is off when i turn on the print Faulty control board. contact service center. If you wish to get some details; check the site linked here. Pull up older posts.