Questions & Answers for: Mercedes-Benz cable lock

Cable (40B) Pull jacket in direction of arrow until lock lever (44B) rests against the cam (48). Ball nipple of cable (40L) Clip in and insert. Cable (40L) Pull jacket in direction of arrow until lock

...1987. i had to change the ignition lock barrel. there was no barrel before and i have all the 7 cables outside. I can not find the right position of each, there are 2 reds,1 little green, 1 big ...

...ign lock and replacement of five components ,OK but when is it going to happen again? Can anyone offer advice please? be sure the cable from shifting mechanism to ignition swicth are properly

...battery on mzb e320 hello ,your battery is located at rear seat (right side) remove the negative cable first ,then when installing the battery ,positive cable first to install, after replace your ...

...lock ( press button) alarm fob ( press button) or using the keyless entry/go system the hazard lights flash really quickly. They shut off for about 30 seconds and then start again. But the alarm is ...

LOCK disconnect battery ground cable leave 5 minute then fix ground cable back it will work if not, could be faulty center locking pump or fuse for pump, fuse located below right rear seat if you have

lock when pressed and handbrake releace lever loose their is a cable from the release lever to pedal and this has a problem ,what i couldnt say without a good look but often the plastic retaining clip

...lock is broken need to charge the battery, how can I do that open the bonnet and place a jumper cable on the starters POS. wire.Place the NEG. cable from the jumper on any metal structural componant ...

My mercedes cls 350 2010 cable snapped for the drivers door window I replaced the cable and it's working fine but the central locking on the drivers door has stopped working check your fuses under the

...lock(s) do not work, perform the following: 1. remove the right front wheel. 2. remove the wheel well liner. 3. buy or borrow a charged battery. 4. buy or borrow a set of jumper cables. 5. attach ...