Question about XXV-03A Mono 25th Anniversary Power Amp Car Audio Amplifier
Protection Function flashing with error code E-2 I am running 2 XXV-03A Mono pushing 2 12" Kenwood Subs each and 1 XXV-02A 4 channel running my highs. I have been running the system for the past 2 ...
amp. When you bridge you MUST make sure that you still have the proper speaker load. One 4 ohm speaker on one channel is fine, but when you bridge that same 4 ohm speaker, it gives you a 2 ohm load on
...amp trigger wire is also working with the key on and the fuses are good.. but i cant seem to get any sound outta the speakers... thanks hi, note that if you are not using the proper gauge b+ and gnd ...
again. The problems i said earlier is now waht happens You have blown outputs , faulty channels. What kind of amp do u have and what were u running to it? Most likely a bad amp, u might need a new one
Kenwood KRF 7775D not working with Digital Inputs I have got Kenwood KRF 77775D. I have same problem as Raffa has. Before 18 month my receiver stop working. I sent it to authorised service centre as ...
...stopped working all together, even when I switched it back. Any chance something came loose inside? The amp is kind of old and well... part of the bottom panel has a decent amount of rust but nothing ...
Question about KFC-W3011 Car Subwoofer
stopped working. Amp indicator still on. My kenwood kfcw3011 stopped working. Amp indicator light is still on. After soft or loud music, the subs stop working after about 15-30 minutes of use. I tried
...stopped. Have not changed anything. PROCESS OF ELIMINATION: connect each of the other speaker in the working to check to see if the wires and other speakers are working. If all speaker play when ...
...amp powers on, remote wire and rca wires are connected and intact. Before it stopped working all together the woofer would cut out and after turning the car off and then back on the woofer worked for ...
Usually answered in minutes!
202 Questions
203 Questions
165 Questions
142 Questions
149 Questions