Questions & Answers for: Toyota 1 6 crank pulley

...pulley without replacing the crank any helpful hint you can give . Yes, in most cases you can. The crankshaft pulley is bolted to the front of the crank shaft by either 1 large bolt and thick washer, ...

...pulley has timing mark. If the crank is lined up to the mark, it is at TDC, meaning cylinder number 1 piston is at TDC. Both cam pulleys should have marks, they just look a little different. Here are ...

my diesel corolla car engine crank puly came out from the rubber bonding so please let me know wahat to do to bond the pulleys back to the crank pulley New only

...right there at the starter. it is a little piece of metal.remove it to gain access to the fly wheel or get someone to hold the crank pulley.you will also need a wheel pulley to remove the crank ...

...be to torched the BOLT untill it loosen up! Removing and torching it, might as well replace the CRANK OiL SEAL, carefull not to burn the CRANK PULLEY, some have a RUBBER insulation in the mid

...CRANK PULLEY. 2 . WHAT CAN HAPPEN IF YOU DRIVE THE CRUISER WITHOUT A DAMPERPULLEY The damper pulley, on the end of the crank is what drives the belts for pretty much everything else. the engine will ...

runs horrible. just had a tune up before replacing pulley and it ran like a top and now it runs rough, no power,sounds like its missing. can anyone help? crank sensor damaged when changed crank pulley

...crank pulley on bare metal. is this correct or has the crank pulley moved out wards from motor? The crank pulley is a 2 piece part, the outer pulley "ring" is insulated from the inner pulley by a ...

crank pulley, on some later models the crank position sensor is located in the timing cover near the front next to the pulley, it has a wire coming from it going up to a connector near the alternator,

...shred I've already replaced the tensioner pulley and idler pulley My experience has been a problem with the crank pulley moving forward causing the belt to not fully seat in the crank pulley