...pulley you rock it free loose it off don't retention on wear the nut won't fit in bolt hole tension is with p/s pump and not versa the crank , then once practise the same nut insert you can't see ...
crank angle sensor. start your car then wait for it to stop again then pour a descent amount of water over it then start your car again. if that works, u will need to get it replaced. sensor is to the
Question about 1998 VT Commodore
...if this is at fault when it stops pour cold water over left side of crank pulley where sensor is and try and restart if it restarts its the sensor Vx commodore keeps shuting down between10 15 ...
Question about 1998 VT Commodore
crank pulley must line up with mark on cover then there is a special tool that lock both camshafts at rear in the flat slots as well as lock pin to put into hole in block that locks cranck shaft. then
Question about 1999 VT
crank pulley has separated from rubber. when motor is not running can you grab the serpentine belt and move it along rotate it from left to right side of vehicle until it clunks to a stop which is the
Question about 1999 VT
...crank pulley, bring the # 1 cylinder up to Top dead center on the compression stroke,. It will read Zero degrees on the timing mark scale. look at the cam gear closely and you will see that there are ...
...crank and water pump pulleys. The alternator pulley is steel and all these pulleys are smaller than the stock pulleys. Be prepared to replace the crank and water pump pulleys for they ware out faster ...
Question about 1999 VT
...crank shaft pulley bolt for a 1989 Holden rodeo The best solution you'll get from books at www.reliable-store.com These are books containing info on repair, service, troubleshooting, parts info, ...
Usually answered in minutes!
179 Questions
93 Questions
85 Questions
57 Questions
45 Questions