Hi, on Konica-Minolta Bizhub C450 printing speed is very slow. Attached to Ethernet, Data via TCP/IP. Speed 100 MBit fullduplex. Sending a full color A4 page with 300 dpi; f. E. from Photoshop. The C450 shows the blinking green Data LED for about 10 minutes. Then the printout begins. 10 minutes; impossible I think. The Computer OS is Win XP or 2000, the driver PS or PCL 2.50 or PLC V3.01. All the same behaviour. Can you give me a hint? Any known dependences? Amount of Memory of the C450, Firmware, Settings?

SOURCE: bizhub C450 error (C-0212)

Hi,

I've just had the same problem - empty the LCT and close it. Open and close the front door of the machine. This should clear the code (it worked for me). Then reload the paper in the LCT as previous

SOURCE: proplem with KONICA MINOLTA bizhub C450

c-3451

SOURCE: Ocr scan for Bizhub C450

Hello,
according to what I read on the C450 biz hub, in order to do OCR you need to use the option that scans to SMB, that sends the scanned documents to your computer on the network. You can then process the documents on your computer with the OCR software program so you can edit the finished documents. I did not see anything that indicated the Bizhub had OCR software capabilities built into the unit. Regards, rcampsr

SOURCE: Imaging Unit Problem with bizhub C450

On the end of the image unit you will find a white bit of plastic with a small screw in the middle, make sure this screw is tight and then reinstall the units(give the units a bit of a shake too)

SOURCE: Printing labels on bizhub C450

Hi nwillett,
Yes and no, sorry if that doesn't make much sense.
For years Minolta recommended Avery labels, but these days they recomment labels manufactured by Howard Smith Papers, their website is http://www.hspg.com/
The thing with labels is always to use the one your copier service company suggests. Otherwise they'll invalidate you contract and you'll be liable for callouts and repairs caused by using Avery labels.
However, Avery labels are good and I have experienced very few problems with them I pressume you using the lables in the correct orientation and also using the manual bypass to feed them.
Regards
Taminol