Ge stackable wsm2700dawww Dryer making noise,maby belt,and not drying very well.

Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

GE HAS A REARBEARING THAT GOES OUT OVER TIME .. NORMAL WEAR AND TEAR FROM USE COULD ALSO BE YOUR HEATING PROBLEM IF THIS IS ELECTRICAL DRYER TUB COULD BE GROUNDING ELEMENT

3 year old GE stackable washing machine, had water coming out the top and would not drain or go through cycle, when shut off it drained a little but when turned on again it filled up and over flowed.

sears will give you 10% towards your next purchase if you call them out for the repair and decide not to do the repair. but will cost you the trip fee. depending on what is actualy wrong with the unit, every repair person is going to give you their own price. w/a model # and the problem all i can do is educate you on parts costs... hope this helps

Hi,
Try these

1. Balance the load
2. Level the machine
3. Inspect the water pump for a blockage
4. Inspect the coupling
5. Inspect the transmission
6. Adjust the drive belt tension
7. Check the motor bearings
8. Check the drum brakes

pls rate my suggestion........

9 out of 10 times this is due to a bad roller. This is not something you can do yourself. A stack model is just too complicated.

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

if you have a broken belt... remove the back. and the drum support. then you can remove the belt... and replace it with the new one...pull back the pulley and them loosen the belt... let me know

If youve made sure that its not a roller thats dry or a belt idler pulley that dry,than yes its the motor,and oiling that will only make it worse.

drum bearings are going up

If it stops running when hot it may be the motor. The belt or drum rollers would not stop it from running.