At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
I just bought a Just Wireless BT-15K. When i plug it into the charger my first indication that something is wrong with is the Red light will not stay solid it dims and blinks every 10 to 15 seconds i left it plugged in for three hours. when i unplugged it to pair it won't turn on. is there a solution or do i have to take it back.
ok i finally got it to charge right but now it's been charging for 14 hours and the light has not turned off and when i unplug it it will not turn on... am i doing something wrongok i finally got it to charge right but now it's been charging for 14 hours and the light has not turned off and when i unplug it it will not turn on... am i doing something wrong
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
A solid red and green light on your QIANHUI 60 volt ebike charger usually indicates that the battery is fully charged and the charger is in a standby or maintenance mode. When the battery is fully charged, the charger will automatically switch to this mode to prevent overcharging and prolong the battery life.
If the lights remain solid even after unplugging and reconnecting the charger, it could indicate a problem with the charger or the battery. Here are a few troubleshooting steps you can try:
Check the battery: Make sure the battery is properly connected and functioning. You can try using a voltmeter to test the voltage of the battery. If the voltage is too low, the charger may not recognize it and remain in standby mode.
Check the charger: Make sure the charger is properly connected to the power outlet and the battery. You can try unplugging and replugging the charger to ensure a good connection.
Check for faults: Some chargers have a fault indicator that will illuminate if there is a problem with the charger or the battery. Check the user manual or contact the manufacturer to see if your charger has this feature.
I recently fixed my 955 headphones... it's probably not going to be attempted by most folks, but it saved a great set of headphones from being tossed and replaced.
Basically you need to remove the right side padding and take out the 3 screws. This gets you access to the battery. The battery is a standard 3.6V lithium battery. Pretty much the same that is in most cell phones and many small toys. You can simply replace the battery with something like: http://dx.com/s/3.7v+li
Or... here's what I did... add a lithium USB charger to the battery. http://dx.com/s/li+arduino Now, if the battery dies I can plug it into USB and the phone will work while it charges.
read the owners hand book
normally the lights stay red until the battery is charged then it goes green
if the power is cut or if you switch the point off with the charger still in it and do not remove the charged battery , the battery will discharge through the charger
sounds like a dead battery. Plug the origional charger into it and the front led (below the flash) should flash red. If the red led in the back of the camera flashes or stays lit, then you have the wrong charger plugged in. (the camera won't power up if the back red/green led is on when plugged in)
ok i finally got it to charge right but now it's been charging for 14 hours and the light has not turned off and when i unplug it it will not turn on... am i doing something wrong
×