I have stacked washer dryer. It runs, spins but it doesn;t drain. What may be the probable cause?

Control board issue, call a repair tech....

You have a timer problem, the contacts are welded in spin mode.
This is almost always caused by advancing the timer by hand when the dial is pulled out in the "ON" position, causing arcing of the contacts.

Get the control panel off and remove the water pressure tubing. Blow it out and reconnect to pressure switch. Remove water so that pressure can once again build inside the tube. Retry>



If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hello, try to checked the pump filter, and the pump is actually working. then I would suspect a draining problem.
If filter clean and pump works fine then it could be a control module fault. if this were the case, then it would probably be wiser to purchase a new washer.
Thanks

remove the front panel and check the water pump

First, see the Sears parts site for your washer:
http://www.searspartsdirect.com/partsdirect/index.action

Enter your model number (###.######) and you'll see a list of major sub-components with diagrams and parts.

Without a complete model number, I'm guessing but usually, washers have a lid lock built in that prevents the washer from draining or spinning unless the lid is closed.

If the lid lock is defective, the washer probably won't go into spin mode.

Check yours for the lock, where it attaches and replace it. It's probably not too expensive.

its your brushes on your motor or the motor itself but my guess is the brushes replace and enjoy

you probably have a clogged drain on the washer

washing machine is leaking from the bottom left what could this be
?

check the timer