After buying this model watch bracelet links are rusted and torn with one year of purchasing. When i took that watch to the show room where i purchased. They kept it for 40 days saying that they has to send it to the company. After 40 days when i got back my watch i found the bracelet was grinded and one link was removed which caused the bracelet became tight to my wrist. Again it was rusted and this time got out of my wrist fell out on the road . Carefully took the watch to the show room there i dont find similar or suitable bracelets for my watch there is no proper response from them. What can i do?

you can write companyy still needs to be put on, I would try tourneau. they ship too.

Try and get it ultra-sonically cleaned, It won't cost much at all.

mcdevito75 here, BEST BET, look for a small watch repair shop in your area for a replacement band.

Scratches are not removable - you have to buy new glass as well as bracelet. Use this link to call stores in USA. There are no stores in Philippines. http://www.calvinkleininc.com/calvinklein/stores.aspx

Go to watchbands.com, enter your model number and bracelet size and problem solved!

NEED TO LINK TO ENLARGE THE BAND ON MY WRIST WATCH

If you are ready to take that risk, here is how you can do that.
First- get watch on your wrist and by squeezing the bracelet count how many links you have to take out to make it tight enough (say 4 for example).
Check the sides of a bracelet. You will notice that the upper bands metal is flipped over the bracelets side. Take tweezers or small pliers and unbend one of these. Try to do as little damage as possible.
When it's done, you will see two metal staples inserted into the bracelet. You have to pull them out. While pulling out, remember how they where positioned, as you will need to drive them back in the same manner.
So, when the staples are out, do the same on the other side of bracelet. Now you have bracelet in two halves.
Count off 4 links and undo the staples in joint of 4th and 5th link in the same manner as previously.
When links are out, take the staples and drive them back into the bracelet koining two ends together. You have to do that exactly the same way and position as you took them out.
When all staples are in place, bend the metal back over to the bracelet sides.
BE WARNED: as you gonna do it first time, be ready that you can damage the bracelet or can not put it back together.

Good luck.

Rate me, please.

If you are ready to take that risk, here is how you can do that.
First- get watch on your wrist and by squeezing the bracelet count how many links you have to take out to make it tight enough (say 4 for example).
Check the sides of a bracelet. You will notice that the upper bands metal is flipped over the bracelets side. Take tweezers or small pliers and unbend one of these. Try to do as little damage as possible.
When it's done, you will see two metal staples inserted into the bracelet. You have to pull them out. While pulling out, remember how they where positioned, as you will need to drive them back in the same manner.
So, when the staples are out, do the same on the other side of bracelet. Now you have bracelet in two halves.
Count off 4 links and undo the staples in joint of 4th and 5th link in the same manner as previously.
When links are out, take the staples and drive them back into the bracelet koining two ends together. You have to do that exactly the same way and position as you took them out.
When all staples are in place, bend the metal back over to the bracelet sides.
BE WARNED: as you gonna do it first time, be ready that you can damage the bracelet or can not put it back together.

Good luck

I took mine to a watch store, and had them remove a link.