Whirlpool Quiet Partner 980

Hello,

press normal heated dryer normal heated dry normal the dishwasher should reset and start. You will need to check the heater this happens because the heater normally fails. Let me know,

http://www.appliancerepairlesson.com/

whirlpool Quiet partner 3 the clean light is flashing 7 times what does this mean

most of the time this meens your heat element is burnt out.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/dude_653d05454b389bba

heated dry and high temp wash
toggle till all the lights light up
then hit cancel
you should be able to turn dishwasher back on
you probably have a bad heater
is it flashing 7 times
take kick panel off and look to the rear of the dishwasher
is anything burned
if the clean light keeps blinking replace your heater

Had the same problem. Press the sani-rinse and heated dry button back and forth and it should reset.

you need a new cycle selector ...or "timer "....

you have to hit heated dry and normal and toggle these till all the lights light up. then hit cancel . you are going to have to turn the power of and slide the dishwasher out and look directly behind the dishwasher you will see that a wire off of the heater is more than likly burned of repair the wire you should be fine. replug dishwasher in after wire is repaired. if you do not have a burned wire you have a bad heating element replace the element.

do the heated dry and hi temp and then hitr cancel. you know what this means?! you have a bad heating element usually. call for service this should be a covered repair if it is only 6 months old

Bad control board ,replace it.

I too had Flashing Clean light and only responded to Cancel light by trying to drain. Whirlpool Model DU1145. I too got problem to clear by pushing High temp,Heated dry, High temp and Heated dry. All lights on display lit up then it went through sequences of all cycles.