My minolta sightseen camera wont take pictures?

unless you put the battery in wrong There is a small diagram on the lid part or in side where the batteries go showing which way the batteries are put in.

If Try one or more of the following

Ready light does not turn on and the camera does not work.

• Turn on the camera (Turning on the camera).

• Install new batteries (Loading the battery) or charge rechargeable batteries.

• Turn camera off, then back on.

Ready light blinks green.

• Camera is operating normally.

Ready light blinks amber.

• Wait. Resume picture taking when the light stops blinking and turns green.

Ready light blinks red and camera turns off.

• Install new batteries (Loading the battery) or charge rechargeable batteries.

Ready light glows steady red.

• Transfer pictures to the computer (Transferring pictures with the USB cable), delete pictures from the camera (Deleting pictures/videos), switch image storage locations (), or insert a card with available memory (Using an optional SD/SDHC or MMC card).

• Wait. Resume picture taking when the light turns green.

• Change the image storage location to internal memory (), or use a different card.

Ready light is off or glows steady green.

• Camera is operating normally

Red light indicates that the camera is out of charged., Try to charged your battery for 3-4 hrs if you encounter flashing red on a fully charged battery you need to call kodak 1 800 235 6325 ext 12

You can charged you camera using 5V AC Adaptor or a USB cable taht attached into the computer

Make sure you are using the correct batteries, and that they are installed correctly. Some cameras require more powerful kinds of batteries and will not work with the cheaper kinds.
A blinking light can mean something is wrong with the power, not enough or something else.
If you have a power adapter or can get one, you may try that, to see if the camera will work without batteries. If it does, then some problem exists in the battery circuit.

Remove the batteries and clean the battery contacts inside the camera with a soft cloth (a heavy buildup on the contacts may require cleaning with a fine wire brush, steel wool, or sandpaper). Remove any residue that the cleaning leaves in the camera, and then reinstall the batteries. This clears most power-on problems, but if yours persists, check the Kodak troubleshooting guide at:

http://www.kodak.com/global/en/service/repair/troubleshooting/troubleshooting.jhtml?pq-path=6198

Contact the person @ www.digitalcamrepair.com he can repair it for you.

This can sometimes be fixed if you remove the batteries over night and allow the camera to sit and discharge it should correct this problem. hope this helps.

my A360 digital wont turn on it flashes green then goes off i put new batteries in it

Here are some simple things to try first for a camera that won't power on:
http://camerarepair.blogspot.com/2007/11/simple-fix-for-dead-cameras-that-wont.html

What type of new batteries did u put, same as original ?