Need manufacturer's 3 digit code for Model EWV404

Hello,

Usually channel 3 is picked up on a channel scan when there is an input device connected to the TV via a Coaxial Cable, thus using only channel 3 on the TV itself and using the Digital converter box to tune in the channels.

The TV will need to be Digital ready to connect only a Digital Antenna to it and programmed to receive the Digital Broadcasts over the air. If you are certain that this TV is Digital Ready (TV manufactured from 2009 to the present) you can use the menu button on the top, side, or front of the television, then use the channel / volume buttons to move around the menu, and the input button as the enter button.

You will want to select Antenna (ATSC) signal before starting the auto program so the TV will be able to recognize the Digital Channel Broadcasts.

Hope this helps!

Cheers,
Scott

Hi,

You need to hook the VCR and the DVD recorder to the scart connections on your TV.

VCR to one scart on the TV
DVD recorder to the other scart on your TV

It sounds like the remote would need to be programmed to the receiver itself. It may have lost it's programming when the TV code was put in.

To program remote to Satellite:
1. Access System Information screen.
2. Note the # on the bottom where it was Secondary Remote Address.
3. Hold SAT until all buttons on top of the remote light up.
4. Let go and while it's blinking enter a number between 1-15 and press #
5. Press record 3 times and test remote.

Tommy Faust
DISH Network

Hi jollycay there is something else you can look at, youwant to press the Menu button and then press the numbers 6-1-3. It will takeyou to System Info 1, you will need to see if field F is green and if so I do apologizefor the loss of the recordings due to we have no way of recovering them. If thebox is not green please call in so we can take further action.

Mike Houston of DISH Network

I don't see anywhere in the program menu to input a channel number to be recorded, only date and time.

cal the main manufacturer

try 588

I don't know the sharp(mfg) code to activate my universal remote

go to the menu and select auto find or auto program channels.
good luck
please mark the post with a fixya!

Barring the right codes to make this thing work, I have resorted to running the numbers (ie 000 thru 999) to "stumble" across the right combination...accordianman