Hello, I have a Soutbend cooker serial N° NX

Amica Cooker & Oven Parts ' BuySpares

www.buyspares.com > amica > cooker-oven > catalogue

Repair your Amica Cooker & Oven appliance with a part from our extensive parts range. All our Amica Cooker & Oven parts are available to buy online. Missing: AS9EGS ‎' Must include: AS9EGS

Spare parts : Amica

www.amica.pl > Amica.pl > Support

Are you looking for spare parts or accessories for household appliances? Take a look at our store! By taking the next step towards the development of user ... Missing: AS9EGS ‎' Must include: AS9EGS

INSTRUCTION MANUAL - Amica

www.amica-international.co.uk > connector > downloads

PDF Do not use the oven until you have read this instruction manual. ... Warning: The appliance and its accessible parts ... Replacement of the oven light bulb. Missing: AS9EGS ‎' Must include: AS9EGS

Amica Cooker & Built In Oven Spare Parts - UK Whitegoods

shop.ukwhitegoods.co.uk > amica-oven-cooker-spare-p...

Spares for Amica built in ovens, cookers and hobs including elements, both fan and oven as well as fan motors, door parts etc. If you can't find the Amica spares ... Missing: AS9EGS ‎' Must include: AS9EGS

Amica Cooking Appliance Parts & Accessories for sale ' eBay

www.ebay.com > Amica-Cooking-Appliance-Parts-Acc...

Results 1 - 36 of 36 - Amica Cooking Appliance Parts & Accessories ... Genuine Amica 507EE1.30HPFGW Cooker Oven Hob Knob 9051787 - White. $30.22.

need a model number please

Hello Malcolm Shaw,

Lamorna 4400 resolves to the other side of the earth on the bottom half... Looking for "PARTS" (usa: here) didn't work
"SPARES" did... (not dawn here yet = SF Bay Area)

I was looking for a nice VENDOR VIDEO...
"you-tube" videos vary from reality... (a wee bit)
or are just plain wrong.

Sorry I could not find you a direct answer.

My best advice is to "CHAT" with a "SPARES"
retailer (example below)

Lamona Spares Spare Parts Appliance Spares Appliance Parts BuySpares

Indicative of a failed element. Remove the contact leads and test with a meter.

Appears to be a Polish brand?

Amica Cooker & Oven Parts ' BuySpares

www.buyspares.com > amica > cooker-oven > catalogue

Repair your Amica Cooker & Oven appliance with a part from our extensive parts range. All our Amica Cooker & Oven parts are available to buy online. Missing: AS9EGS ‎' Must include: AS9EGS

Spare parts : Amica

www.amica.pl > Amica.pl > Support

Are you looking for spare parts or accessories for household appliances? Take a look at our store! By taking the next step towards the development of user ... Missing: AS9EGS ‎' Must include: AS9EGS

INSTRUCTION MANUAL - Amica

www.amica-international.co.uk > connector > downloads

PDF Do not use the oven until you have read this instruction manual. ... Warning: The appliance and its accessible parts ... Replacement of the oven light bulb. Missing: AS9EGS ‎' Must include: AS9EGS

Amica Cooker & Built In Oven Spare Parts - UK Whitegoods

shop.ukwhitegoods.co.uk > amica-oven-cooker-spare-p...

Spares for Amica built in ovens, cookers and hobs including elements, both fan and oven as well as fan motors, door parts etc. If you can't find the Amica spares ... Missing: AS9EGS ‎' Must include: AS9EGS

Amica Cooking Appliance Parts & Accessories for sale ' eBay

www.ebay.com > Amica-Cooking-Appliance-Parts-Acc...

Results 1 - 36 of 36 - Amica Cooking Appliance Parts & Accessories ... Genuine Amica 507EE1.30HPFGW Cooker Oven Hob Knob 9051787 - White. $30.22.

Lots of spares available online.

https://www.google.com/search?q=spare+parts+for+an+Amica+oven+AS9EGS&rlz=1C1QJDB_enCA643CA644

..

Really bad but how we are supposed to help you? Find a shop where they sell parts for Zanussi ovens.
Most I can do for you is to provide you some websites selling parts for zanussi: ovens

Official Zanussi Site Parts Accessories for Appliances


Zanussi Cooker Oven Shop


Zanussi Cooker Oven Shop


Find Zanussi Spares and Accessories


Zanussi Cooker Oven Spares

Oven will not hold correct temperature:------- This can be caused if temperature probe not working.Resistance across temperature probe leads at room temperature (70°F) should be approximately 1096 ohms.----------- Other possibility for this problem is :--- Temperature control not calling for heat.When heat is required, there should be continuity between terminals 6 and 7 on temperature control.-----------Inadequate or improper ventilation.Check ventilation hood. Verify draw and make up air adjustment.-----------If all this checked out ok then its calibration problem.For calibration follow this procedure:--
It can be problem with temperature controller. TEMPERATURE CONTROLLER (Standard-Control Models Only) The calibration of the temperature controller should not be changed until sufficient experience with cooking results has definitely proved that the temperature controller is not maintaining proper oven temperatures. Before any recalibration is attempted, the oven temperature should be checked by the following procedure: 1. Remove all trays and pans from the oven. 2. Place a thermocouple or a reliable mercury oven-type thermometer at the center of the middle rack. 3. Turn the oven ON and set the temperature control knob to 400°F. 4. The amber "heat on" light will go out when the oven temperature is reached. 5. Allow three cycles for the temperature to stabilize. 6. Read the thermocouple or thermometer immediately after the light goes out for the third time, and again immediately after it comes on the next time. 7. If the average of these readings varies by more than 10°F from the dial setting, recalibrate by the following procedure. Recalibration should be attempted only by a competent service technician. Use the following procedure to recalibrate the oven: 1. Loosen the two set screws that secure the temperature-control knob to the temperature-control shaft. 2. Remove the knob from the shaft, being careful not to rotate the knob or shaft. 3. Replace the knob on the shaft so that the indicator mark on the knob points directly at the temperature that was measured at the center of the oven. 4. Re-check the oven calibration. ----------- Part number for temperature probe is 1181996 and you can order if from the Southbend service center. -------- If you want the manual and wiring diagram for your oven.Please click the link directly:-- http://www.retrevo.com/search/v2/jsp/mytrevo/myTrevo.jsp?page=man ----------- after you click the link,a page will open in that you fill the 5 letter number.And click the "download now " option.It will ask you to save or discard.Click the save option and download will start.It will take 2 mins to download.Then click the download file to open it.And go through the manual.------------This will help.Thanks.Helpmech.

we should be able to help if you contact the office

These Videos will help with your cooker problem.
If you need more video help on appliance repairs visit our Video Tutorial Library at our website
1 how to remove your oven door for cleaning or repairs and how to reseat the door when finished.
2 How to change and fit oven door hinges.

We can not allways cover Every model but hope this helps. Remember to send us an email if you can’t find the part you need.
We also supply all the Parts you need for Repairing your cooker oven Door.
Oven Door Hinge Spare Parts
Oven Door Glass panels
Cooker Door Handels ETC
Cooker Door Catches ETC
Cooker & Oven Door Seal / Gaskets

Remember to Leave feed Back and pass our site on to your Friends:
Our Shop http://www.apart4u.co.uk
Our Video Help Section http://www.apart4u.co.uk/video-tutorials.html

Call Rick at Restaurant Parts and More. 1-888-814-1110.
Be sure to have model and serial numbers to get the correct part.

Hope this helps.

Southbend does not have their information for your steamer on-line. You can get your schematic/diagram by contacting them

Contact Southbend Technical Support 919-762-1000

Depending on your local code, you will need an exhaust hood due to the byproducts of the gas burning. Some locals allow for electric ovens to go without hood. Gas units generally require a hood system with proper fire suppression equipment. You may want to check with your local fire and building inspectors.