The initial setup function will not boot up when the tv is turned on. The tv is set to cable instead of antenna and i'm not able to change it via the initial setup - or anywhere else in the software.
Try resetting the TV to the original factory settings. After resetting the TV to the original factory settings, you can get the initial setup screen to select Antenna. Make sure that the cable from the Antenna is connected to the TV.
Follow the steps given below to reset the TV to the original factory settings:
(i) Turn ON the TV.
(ii) While holding down the Up arrow button on the Remote control supplied with the TV, press the Power button on the TV set. The TV will turn itself off then back ON again.
(iii)Next, release the Up arrow.
1,193 views
Usually answered in minutes!
×