My basement flooded and now my Whirlpool top load washing machine will lock and sensor turns on but washing machine does not fill...what could be the problem

SOURCE: The duet washing machine fills up with water in between loads. What is Causing This?

Dont want to endorse a commercial site, but you can by a generic part for a bit over $10 for this problem, so do some seraching for a reasonable site (other sites are charging 40-50 dollars for a fill valve.

SOURCE: Whirlpool not agitating

Hi everyone - I ended up calling a repairman. It was small part that needed to be replaced. It cost me $65 for the visit, $20 for labor and $20 for parts. The repairman told me it would probably be good for another 5 years.

SOURCE: washing machine

check pressure switch hose

SOURCE: Whirlpool top loader washing machine - agitator does not turn

If it does not drain, I'd check the water pump first (for an obstruction - I found a sock in my pump and that fixed my problem) ... see this video - the top is getting to the WM drive shaft (transmission), but it shows you how to remove the pump first: http://www.youtube.com/watch?v=WLPGs2UMUJc&feature=related

If it does drain ... Is it just the TOP part of the agitator not working, or the whole thing (agitator is in 2 parts)? If just the TOP, you probably just need new "dogs" (agitator dogs). Check this out:
http://www.youtube.com/watch?v=V5wIN1J70-Y ... it shows you what to do.

If it is the whole agitator that is stuck, that video will show you how to remove it (remove a single bolt) and you can see if there is an obstruction keep the agitator from moving.

If there's no obstruction or the water pump isn't stuck, you might be looking at a new drive/transmission = expensive. Good luck

SOURCE: I have a Whirlpool coin operated top load washing

I hate this
try insert another coin
if not you will have to run a wire through and a frictioned and magnetised coin might help
if you can you will have to dismantle this part in trying to release it