Reset button location dewalt dcr025 work radio

Read the reviews. We see them on Fixya very occasionally and from memory, it was internal fuses blowing.

https://www.google.com/search?q=Dewalt+DCR025

..

This is what dewalt is saying...The Dewalt 12V/20V MAX work-site charger/radio functions as an AM/FM radio and recharges your 12V/20V Dewalt batteries (batteries not included). The 3-stage charger can recharge your batteries in as little as 1 hour, and the radio can run off 12V/20V batteries for cordless operation

• 2 AC power outlets offer more versatility for jobsite power
• Auxillary & USB ports allows for connection to CD, MP3, portable satellite receivers, and other digital audio devices.
• USB port allows device to be charged via USB when radio is plugged into a wall outlet
• Class D amplifier, woofers and tweeters provide full range of high and low sound for optimum sound quality,( hope this helps)

If you bought it at HD return it for a new one. If not you will need to use a meter and check power from receptacle to on/off switch to pressure switch., Check motor winding. If all else fails call Dewalt and they will help you.

This is a common problem with this compressor and still is a problem in 2014.It is under powered and trips the reset

i have put 2 new batteries but cant get radio 2 work

Hi fostert,
Just find the reset button then press it to reset,but if you can't find the reset button,then take it out the power the nicad battery for about 30 minutes. After 30 minutes put it back the battery and power it on and you can see flashing the number in the LCD then that is the time you can set the clock.
Regards; VOTIT

Hello avid.....

If there is no power to the receptacles:

1. Turn the circuit breaker switches off and disconnect all electrical loads from the generator.

2. Turn the circuit breakers on and test the GFCI's by following the procedures in this manual

on page 1 -

TO TEST A GFCI:

Start the generator. Turn the auto idle switch off. Push in the TEST button (A) on the receptacle.

The RESET button (B) will pop out. Power is now off at the receptacle.

If the RESET button does not pop out, the GFCI is not working. Do not run

generator until the problem can be corrected. To restore power to receptacle,

push the RESET button in. If the RESET button pops out during operation,
stop the generator and check the generator and equipment for defects.

3. Place the voltage selector to the 120 Volt only positions (unless you are using a tool that

requires 240 Volts).

4. Turn the idle control switch off.

5. Turn the circuit breaker(s) off and reconnect the electrical loads. Be sure that the plugs are

securely connected to the receptacles.

6. Turn the circuit breaker(s) on.

7. If there is still no power at the receptacles, take the generator to an authorized DEWALT
service center. To locate a DEWALT service center nearest to you, call 1-800-4-DEWALT

Joe

Thanks for choosing Fixya!

check the fuse inside near the transformer.

Check fuses inside. Check fuse and connections in plug. If this is a 110v radio there is one on transformer winding.

take the two aa baterys out and the put them back this worked 4 me