Washing machine LG TR9103AEP IE error what does it mean ?

The "IE" error code indicates that there is a water inlet problem on an LG washing machine. This code appear's if the washer will not fill to the correct water level. There are 3 possible causes for the IE code.
1) partially or fully closed water supply lines
2) improperly attached supply hoses
3) clogged supply hose filters (on machine and in the hoses).

Hi IE means Inlet Error. The machine thinks that it is not filling (as a certain time has passed without reaching level it wants).
This makes sense if water is running out the bottom.
You will need to find the leak. Maybe the tub to pump hose, or the drain pump itself. Once you stop the leak and the machine can fill in the correct amount of time, you shouldnt see the IE error any longer.
Cheer

drain motor not functioning or maybe there is obstruction

IE means imbalance error//balance load//check tub see if any itams stuck in or around drum......

is this an Lg washer ie error code is an water inlet error machine notices low water pressure , you either have kinked fill hoses , plugged screens in fill hoses coming to you watervalves or watervalve is damaged from foreing debris coming into watervalve .........

I believe that it says "IE ERROR". Could this be right? If so it's a 'water input error'. You have to check for a kink or clog to the water hose running to your machine.

Hope this helps.

Hello,
Here are the common error codes for the LG machines.

LG Washing Machine Error or Fault Codes

If you have a LG Washing Machine you may see an error code come up and wonder what it is. Here are the common error or fault codes that will be displayed on the LG machine.

OE

This means that the washer has tried for ten minutes to drain the water out of your machine and the water did not drain out.

UE

This means that the load in the drum is out of balance causing excessive vibration when spinning.

IE

This means that the washer has not filled with water in 8 minutes.

LE

This means that the motor and the control panel are not talking to each other properly

PF

Power Failure – The power has gone out to the machine and then has come back on

FE

This means that there is too much water in the machine

PE

This means that the water level sensor is not working properly

CE

The washer motor has received and over current condition

TE

This means that your heating sensor is not working properly

SE

This means that you had a temporary sensor error

HE

This means that you had a temporary heater problem

DHE

This means that you had a temporary dry heater problem

This will give you a basic idea of what has caused your error code.


Heatman101

IE = Inlet Error. Check for plugged screens where hoses screw onto machine (especially the cold side). Other possibilies are kinked hoses, valve shut off where hose goes to washer, or a bad inlet water valve (the part the hose screws onto), or even a bad control board or bad wire to water valve.

IE is a water inlet error...meaning that the correct water level was not achieved within 8 minutes or it did not reach preset water level within 25 minutes...

CL is child lock feature which can be toggled on and off by by holding the Pre wash button in for 3 seconds.. Hope that helps...

LG has general error codes for all there appliances and the "ie" error code is for the water supply. You either have a kink in your hose, water vavle shut off, or the bad problem your pump is bad.