Panasonic model Na-f70b2 error. U12 and stop motor

How to fix an HTC U12/U12 Plus that cannot read SD card, SD card not detected error [Troubleshooting Guide]

1. First solution: Reboot or soft reset your phone.
2. Second solution: Unmount microSD card then reseat it.
3. Third solution: Erase or format microSD card.
4. Fourth solution: Update phone software to the latest version.

https://thedroidguy.com/how-to-fix-an-htc-u12-u12-plus-that-cannot-read-sd-card-sd-card-not-detected-error-troubleshooting-guide-1088446

Panasonic washers use the U12 code to indicate that the lid is not closed and can't lock properly. Make sure that the washer is level. Check for any dirt or other item blocking the lid from closing. Gently clean the latch area on the machine and the lid. Some top-loading washers use a magnet to activate the sensor. Check if the magnet fell out of its usual position. Replace it if needed.

I found one manual for the NA-F160H6 here: https://d3lfzbr90tctqz.cloudfront.net/epi/resource/r/lavarropas-automatico-panasonic-11-kg-na-fs11p6sag-inoxidable/9f7d726972873eeafa7fb3c6254d61909b7337c8b25a7d85cb824625cdbac4dc . The error codes are on page 27. Unfortunately, I haven't found a parts list for the machine. (I did find one for the NA-FS80X1 in the Service Manual, https://www.manualslib.com/manual/1251235/Panasonic-Na-Fs80x1.html#manual .)

I hope this helps.

Cindy Wells

This has already been answered elsewhere. Search "error code u12 for na f65b2". Find previous answer there

You water drain line needs to be curved above top of tank Water finds its on level The water level is stuck on the full position shake the washer lightly with water inside to release it. It works almost as a toilet tank.

First you have to check door switch
some times rate cut the wire check also

no power suply

it is due to the magnet attached at the tip of the lid. the magnet acts as a sensor that give info whether the lid is closed or open. i got the same problem too but luckily the i found the magnet nearby the washing machine.

First my washer stopped working during the spin cycle, and some of the water still in the tub,i have to wait for about half an hour to have the whole process done after continuing the washing process,then after 2 weeks not doing any laundry, when i tried to switch on the on/off button,it doesn't do anything at all!I tried changing the plug fuse(thinking maybe it needed to be changed after 4 years using it) but nothing happened.please help me . TQ