Reset sequence GU940SCGB2 - Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Canon has changed all of the new printers and eliminated the built in reset ability of the printer. You must have specific software to access the Service Mode and from there you can reset the waste ink counter. Contact me at [email protected] for detail

Hi,
Here is a tip that will help you to find out why water will not come into thedishwasher...

Dishwasher Trouble No Water entering Dishwasher

heatman101

Make sure that the projector is in standby mode and perform the following:

Press the following keys on the control panel in the following sequence for less than 5 seconds each: RESET, , ENTER

In english: RESET
LEFT ARROW
RIGHT ARROW
ENTER

Please note that this sequence is documented on page 43 of the user manual under changing the lamp.

Dan

Looks like micro-controller fault.You may have to replace this. Check with the manufacturer's
service center.

Unplug for 40 minutes to reset this unit.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

The SR150 and SR250 remotes can be re-imaged. The V2/1 remotes cannot, any problems they have are always battery related. Remove old batteries and wait at least 2 minutes then replace with new batteries. This will reset the remote but you may need a technician to reset the Zigbee network.

remove battery for 6 hr and reinstal and then hard reset.
bob.

maybe you have a ghost

there is a fuse just before power enters the control panelwhere the line goes in check that first bet its open

try the reset button sequence i posted in the other question..