Accidently hit stick in side yard. now wont throw snow. Everything else seems good

the motor runs but the auger does not , if so the bolt snapped in half from hitting something that you should have not hit , this is a normal thing so as to not blow up the engine , it is a safety feature in all snow blowers , just get the right bolt or make one grind it down to where it will break easy but will work the auger , they sell them on ebay for a couple bucks but I make mine

may need the collision sensors reset..try this disconnect the battery negative with th e key in the run position, then shut everything off and reconnect the battery.. then turn the key to thr run position for a few seconds...this resets all the factory presets.. see if the car will start..repost findings...

once tire is off get a large hammer (2 - 3 ) pound and hit drum several times on the face of drum and along the outer area to brake it free, most times the center of drum rusts to axle shaft causing it to stick. dont be afraid to hit the bastard !! and then use larger screwdriver and install behind the drum between the back plate and pry off while hitting opposite side from the back with hammer. I recommend putting on lug nut just enough to cover the threads on lugs so you do not accidently hit them with hammer. and yes you will !! then remove nuts upon drum removal

Sound like it has water damage the only thing u can is put it in a every hot room r place for a day and then try to turn it on.

I would go to a pick N pull salavge yard and buy an entire used bumper assembly.

http://groups.yahoo.com/group/villagerquest/

it will run at the speed you set at it may bog down a little when you hit the snow and the belt problem on the side there is a cover take it off there is an ajustment try to tighten the belt if that doesn't work you may have to replace it, thank you.

Try Penetrating Oil Such as (PB Blaster) In the LOCK first . It is Hard for me to Connect the Accident to The Lock not Working It Really Had to have Hit it Hard , Unless The Front Wheel on that side Was Hit This Would Effect the Steering Hence the Ignition. Lock. Try the Penetrating Oil on it Its Obvious you Understand the Connection between Steering Wheel & Ignition Lock If this Fails The Ignition Lock Should Be Replaced. I hope you Have Luck with The Lube Fix As It Is SO Much LESS EXPENSIVE Than Replacing the Lock, Good Luck

Did you accidentally hit the lower left "Disp" button on the back of your camera? It manually turns the screen on or off to save batteries. Turn the camera on and press it once to check.

on dell monitors they have buttons on the front (at least the old ones do).   If you can't see things on your screen like task bar on the bottom, or anything on the top and sides --- try adjusting this buttons.  They control vertical size, horizontal size, etc. -- also position on the screeen    If you accidently hit them (I did) it throws everything off.
good luck

you may need to prime the new cartridge by "charging it" if you go to printers/faxes menu then select "printing preferences" and clcik on the maintenance tab you should have the option to do this also to reset to default settings.