How do I use my Whirlpool bath?

There are three main things to tackle when cleaning a hot tub or whirlpool bath. Those things are:

1. Bacteria
2. Grease
3. Grime and dirt

To address all three of these issues you'll likely need separate products. There are liquid versions of the degreaser and cleaner, and there are tablet versions for sanitizing.

Simply fill up the whirlpool bath with warm water, put the cleaning liquid in the cleaning outlet (or if you don't have this, just pour it into the bath). Put the tablet in the bath and then just run it.

This should do the job.
Pure Spa Whirlpool Bath Spa and Hot Tub Cleaning Kit

Might be a typo in the manual typically the latch is moved to the right to close and after clean is over move to the left to open. BE SURE TO REMOVE RACKS BEFORE CLEANING

a good electrican will check for power but may not be able to test a printed control board. Maybe simpler to get a spa repairman

go to jacuzzi.com - downloads

im not a great expert in this field but try putting some dish washer tablets in water when running to see if they can clean out anything,about 3/4 tabs

you will have at least a foot of flexable water hose. Pull it out slowly to make sure its not tangled.

open the side panel and there will be a sticker on or near the pump with all the info

whirlpool tub has jets that circulate the water, where an air bath uses bubbles that rise gently from the bottom of the tub. Whirlpools are typically used for therapy, air baths are used for a much gentler experience. Air baths can be used with aromatherapy/essential oils. Both offer a spa-like experience.

When we move the drum, even with our hand, about 1/2 way through, there is a loud clicking, popping type noise? Sounds like a train is coming through the house before it stops the cycle?