Main menu on the lower right hand side keeps popping up

swipe to the left of the message ( main message menu ) a box will pop up on the right hand side to delete or save.

It's not a very good solution, but you can open the monitor and disconnect the button-panels plug on the mainboard. Afterwards the buttons don't work any more (surprise) but the control panel disappears.

this is a normal condition for that kind of monitor, because it was design only with Samsung syncmaster 731n in which the old model. The reason why it always popping up is because it always adjust the setting of the images. The only way to solve this problem is if this menu appears again you only press the reset button there at the left side of the power button.

It's possible that you computer specks are not up to par for the game. Not all computers are build the same.
Check it on this web site http://www.systemrequirementslab.com/cyri/
You also can try lowering the setting by following these steps

• Launch The Sims 3.
• Click on the blue '...' Options menu on the lower left-hand corner.
• Click on the 'Options' menu item.
• By default, the Graphics settings tab should be the first tab open.
• Slide all the Graphics sliders to 'Low' under the 'Graphics details' section.
• Click on the blue check mark button on the lower right-hand side of the Options window to save your changes.
• Re-start The Sims 3.

Hi, 5barndore,

If you're using Windows 7 this should solve your problem:

-Click on the start button in the lower left hand corner
-Click on "Control Panel" on the right hand side of the menu that pops up
-Select "Appearance and Personalization"
-Under "Display", click "Make text and other items larger or smaller"
-Select "Medium" and then click apply
-You will need to log out and log back in
-If this is still too small, repeat the process, this time selecting "Larger"

Hope this helps!
-endercoaster

try reinstalling the VGA card driver if the problem still insists, then it could be inside the monitor.

Hi,

You must reset the on screen display in the menu. Hold down the Menu button for at least 60 seconds. A menu list will appear on your monitor screen. Using the adjust button, press the arrows to enter the menu. Scroll down to the Reset section.
On the right side of your screen, you will see an alternating Yes/No choice. When the Yes message flashes, press the Ok button. The menu should be reset and the flashing OSD control message should disappear.
I hope it helps.
If you would like to vote for the answer, this will help the others to see the similar problems solved and also will be a satisfaction factor for me to continue helping you.
All the best.

If you are comfortable, take the back off and on the lower right hand side, locate the control IR pickup board. (The Remote sensor). Follow the ribbon cable and relocate that wire away from the inductors on the X board.

You could also try a software update. That may fix the problem.

Your screen settings are not optimized for that monitor, most Gateways (to h*&%) come with a drivers disks for the monitors put that in and run setup for the monitor.

Hi,

Press the Menu button ( marked OK) for one minute, or more, and a blue/red menu list should appear on screen.

Using the adjust button (immediately to the left of the OK button) by pressing the arrows at each end up or down as required you can enter the menu and select an action by scrolling.

At the end of the list of possible adjustments on the left of the screen (brightness, contrast, etc) is the Reset section.

On the righthand side of the screen is a flashing Yes No choice which automatically alternates.

The trick is to select the Reset choice on the left and while selected press the OK button when the Yes alternative on the right of the screen is flashing.

You VDU should then Reset and all will be well.