Hi I have replaced a similar J-Springs battery but was baffled by the label on the inside of the watch back "after installing the battery, be sure to short + on battery with 'Area AC" - I do understand the principle but where, or what, is 'Area AC' please? Your advice would be appreciated.
SOURCE: Opening back of watch for battery replacement
Turn the watch sideways & look around the edges of the back of the watch. You may have to use a magnifier to do this. Look for an area that has a gap. Put the knife there & pry it open. Hope this helps.
SOURCE: Replaced battery, now no beep.
I have a Timex Digital Heart Rate Monitor 585 (product code T5C351F5)m, which has the same Short AC Pad and battery +ve message. There is an arrowhead pointing to the pad. It's a raised metal platform - a bit different to some of the Ironman's mentioned above. Here is a pic...
SOURCE: I am trying to change
I have a similar model. The electronics sometimes needs to be reset after the battery is changes. Get a magnifying glass and look closely at the stainless frame around the battery. There is a small AC mark and a triangle which points toward a small gold contact down in an adjacent hole. This contact must be shorted momentarily to the + side of the battery to reset the display. You can bend a metal paper clip to make the connection. You may have to try several times before it resets. It should reset to 12:00 and start running.
SOURCE: how to remove back for battery replacement - 19
This is a little tricky, I think this has a screw on back. It takes a two or better a three prong tool to remove back. A new seal shoud be on hand to replace this. Watch should have a consumption test and a min run voltage test, if either of these fail a new circuit board or movement should be installed. Take it to a good watchmaker and they will clean the outside before opening and do a water resistance test after assembly.
SOURCE: reset timer after battery change in seiko sna285
If the stop watch hands are not in the "0" (12 o clock) Position, follow the prodedure below to set them to the 12 o Clock position
1, Pull the crown to secound position
2, Press Button "A" for 2 seconds.
3, Press Button "B" to Adjust the minute Hand to "0" Position
4, Press Button "A" for 2 secounds then press Button "B" to adjust secound hand to "0" Position
5, Press crown into normal position
From:
AmFix Jewelry & Watch Repair
203 N. LaSalle Street,
Chicago, IL 60601
Ph: 312 641 7000
Email: [email protected]
Web: www.goamfix.com
353 views
Usually answered in minutes!
×