Overhead door legacy model acsr10 will not work

All questions need full 'make model (what it is) please as first 3 words.

Garage door? We have a Category for that.

Plus what? "and it likes about inch closing all the way"??

Legacy (496CD/B and 696CD/B) - Overhead Door Parts

Overhead Door Parts Online https://overheaddoorpartsonline.com > legacy-496cd-...

This circuit board has been redesigned and will be substituted with part #36190T Overhead Door Model: 496CD/B, 696CD/B Genie Model: PMX300IC/B,... MSRP: Was ...

phantom-legacy-installation.pdf

Overhead Door https://www.overheaddoor.com > Documents PDF b. Blocks of wood, etc. may be substituted for extensions. • Center bracket on ... Model 696 - Motor Lifetime* and all other parts 5 years. Model 777-. CD ...
32 pages

What remote control works with my Overhead Door Legacy ...

overheaddooronline.com https://www.overheaddooronline.com > blog > bid

May 5, 2012 - The model number of the Legacy openers are shown as 496 or 696. You ... B and 496CD/B. There are many different styles and sizes of Code ...

Troubleshooting Guide for Overhead Door Legacy Garage ...

Overhead Door Parts Online https://overheaddoorpartsonline.com > blog > troubles...

Jul 14, 2020 - This blog will help you identify common problems, solutions and recommended replacement parts for the following Overhead Door Legacy model ...

The original Legacy opener came out with a static 390 mhz frequency radio receiver that utilizes 12 security dip switch settings. The model number of the Legacy openers are shown as 496 or 696. You will be able to locate 12 little switches inside an existing remote control or on the backside of the garage door opener motor.
That opener remote will not work. You will have to call Overhead door, or replace GDO with upgraded security and home link to use opener in car overhead. Step 2 lists openers that the glicker will work with.
https://www.overheaddooronline.com/blog/bid/125445/What-remote-control-works-with-my-Overhead-Door-Legacy-opener

could be prompt drive gear or shaft bearongs. You would better off to purchase a Chamberlain from Home Depot Model # HD210 $128.00


https://www.overheaddoor.com/Documents/phantom-legacy-installation.pdf

If this picture at the link shown looks like yours, the red and white cord with the red plastic piece needs to be pulled to disconnect the automatic door opening chain.

http://www.aypapaquerico.info/overhead-door-legacy/overhead-door-legacy-large-size-of-garage-and-modern-overhead-garage-replacement-with-legacy-opener-overhead-door-legacy-496cd-b-manual/

Then, pushing the garage door fully open should move the mechanism back to connect in the ceiling. Then the remote control may work. If not, seek a repair service.

Sounds like a bad fuse block

Replace it before somebody gets hurt!

Legacy openers use the same remotes as Genie Intellicode 390MHZ. Should be able to get one at any lowes or home depot.

Either your sensors are not pointed at one another or the sensor with the red light is bad.

Unplug the opener from the power and take a small screwdriver and pry out on the center contact in the light sockets. There is always the chance the relay that controls the lights may be bad but this is the common fix.

Replace the battery in the keypad.