Wet clothes at end of spin cycle

2 things are possible. Can you tell if the spin cycle is engaging? If the spin cycle is not engaging properly or very fast, then the water will not leave the clothes. less likely is that the machine is not draining the water away properly or fast enough.

Hello,

Either the belt or the transmission. Take the belt off, if it looks glazed, replace it. If not the trans is bad friend.

Check motor capacitors. Check freeness of the drum rotation, if you suspect clutch

The pressure switch is mis-reporting the water level to the ECU.

Test/replace the pressure switch.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

check belt and voltage and try spin with empty machine

Too much laundry in your machine. Try a smaller load and see if you have the same problem

If it goes through the complete cycle o.k. except for the slow spin then the motor itself needs to be checked.

Before going further it is important to determine if the machine is reaching full spin. Make sure the unit is set to MAX extract and watch the inner tub. The tub should be spin really fast (1000 rpm's or better) during the final spin. If not you have lost one of the phases on the motor.

This sounds like a motor control board is faulty. Please load a couple of towels in the machine run it. Watch the machine as it goes through its' cycles.

1. Do the towels tumble when the machine is washing ?
2. When it begins to spin, does it spin one way at a fast pace or does it spin one way and then the other ?

Answering these two questions will help in troubleshooting your problem.

First thing you need to check is the speed of the spin cycle. As long as you are not overloading the machine, it should spin the clothes pretty dry. the basket drive may need to be replaced. If it is spinning very fast, then check the drain hose, make sure the water is coming out nice and fast. If not you may have a water pump problem even lint clogged inside it.