Numbers not completed on display?

Is your drum belt broken?

is it a sensor or heatingunit bad.if lint isnt cleaned reg it will burn out faster also.

Half of the display is only working, the problem is in the driver ic that drives the display, it is simply not cost effective to repair the item, further ahead to replace the calculator.

Hi,
Here is a tip that I wrote about dryers and noises...

It will help you determine what is happening there...

Dryer Repair Squeaks, Grinding, Clicking and Knocking Noise


heatman101

Asker's Testimonial "That answer was very informative - thank you fortaking the time to educate me. " - teresa241964

You would need to get a multimeter and run continuity tests on the thermistor relays as well as the heater which ever one shows you no continuity would be the one that you would have to replace the heater is located on this diagram as part number 110 http://www.searspartsdirect.com/partsdirect/partsdirect/showSubComp.pd?imageUrl=http%3a%2f%2fc.searspartsdirect.com%2flis_png%2fPLDM%2fK0810191-00003.png the relays would be part number 130 and 140 please message me back if you have any further questions and please remember to rank how this opinion has helped in your appliance situation Thanks again
Rick
.ps. the dryer is most likely stopping do to one of the relays they control the tempreture of the machine and if it starts getting to hot then it would shut the machine down

buy anti static balls

hi-limit switch/cycling switch/heating element, bad

are you missing any socks? if so you need to throughly check the duct chamber in the machine, get it serviced this is a fire hadzard.

The following link explains how to properly wire a three or four prong 220VAC appliance:

http://www.fixya.com/support/r793520-3_prong_4_prong_power_cord_conversion

Read through the link provided, and make sure you have the power cord wired correctly at the terminal block in the back of the dryer. NOTE: If this is a new installation, you are required to be using a four-prong outlet with 4-prong power cord. If you have any questions, please let me know. I hope this helps solve your problem.